Hi all, i would like to ask how to fix the highlighted edge to G1 continunity as the flow along surface does not match well the edge of repeated pattern. I hope this will be improved in the future. Thanks.
Here is the link of the file (9.1MB): http://www.sendspace.com/file/16lhqh
I remade this. See if it looks better. There are a few tricks I used:
I think this is looking good. What do you think?
Hi Vincent- I would flow only one repeat of the pattern that is in the middle of the beginning planar version, then, once that is flowed to the cylinder, make a rotated copy, 180 degrees, to fill the cylinder rather than have the seam on the cylinder to deal with.
In the attached image, I just flowed the red part of the pattern, and then made the rotated copy (blue)