Replies to This Discussion

Permalink Reply by Pascal Golay on February 8, 2013 at 4:23pm

Hi Phil- apparently,  this is fixed in the SR1 build. Result attached...

thanks, 

-Pascal

pascal@mcneel.com

Attachments:

• cant_unroll_PG.3dm, 56 KB

• ▶ Reply

Permalink Reply by Phil Pilgrim on February 8, 2013 at 4:29pm

Thanks, Pascal. I don't see SR1 posted anywhere, though. Can you provide a link?

Thanks,

-Phil

• ▶ Reply

Permalink Reply by Pascal Golay on February 8, 2013 at 4:59pm

Hi Phil- it is not released yet but if you open Options > UPdates and Statistics page and set your auto-update to check for 'Service release candidates' it should then go out and find that, download it in the background and at some point when it's all done and you open or close Rhino it should offer to install it.

-Pascal

pascal@mcneel.com

• ▶ Reply

Permalink Reply by Phil Pilgrim on February 8, 2013 at 5:13pm

Hi Pascal,

'Still no joy I'm afraid. I installed the SR candidate and now have "Version 5 (5.1.30129.1756, 1/29/2013)." Attached is the original curve, along with the result of the Unroll.

-Phil

Attachments:

• cant_unroll.3dm, 71 KB

• ▶ Reply

Permalink Reply by Phil Pilgrim on February 8, 2013 at 6:42pm

Some additional info: The problem for RH5 appears to reside with the surface's pointy end. If I trim it off, the surface unrolls normally. Also, the original surface unrolls okay in RH4.

-Phil

• ▶ Reply