In Grasshopper ,I find a question:
I join 1&2 , 3&4 , 5&6, then loft. But can not create my want.(see result 1)
If I loft 1&3&5 ,2&4&6 first. then join. The result like my want,but the two surface no join fully. (see result 2)
Why step one can't create result 2 ?
You have to pick the curves in each group individually and in the correct sequential order that you expect to see in your surface. You can not use a selection box. You don't have any control over the selection box ordering process.
Thank you very much, I succeed.
Welcome toRhino Community
Sign Upor Sign In
Or sign in with:
© 2014 Created by McNeel Admin.
Report an Issue |
Terms of Service
Please check your browser settings or contact your system administrator.