In Grasshopper ,I find a question:
I join 1&2 , 3&4 , 5&6, then loft. But can not create my want.(see result 1)
If I loft 1&3&5 ,2&4&6 first. then join. The result like my want,but the two surface no join fully. (see result 2)
Why step one can't create result 2 ?
▶ Reply to This
You have to pick the curves in each group individually and in the correct sequential order that you expect to see in your surface. You can not use a selection box. You don't have any control over the selection box ordering process.
Thank you very much, I succeed.
Welcome toRhino Community
Sign Upor Sign In
Or sign in with:
© 2013 Created by McNeel Admin.
Report an Issue |
Terms of Service
Please check your browser settings or contact your system administrator.