Grasshopper Curve Join Loft

In Grasshopper ,I find a question:

six curve,

Step one:

I  join 1&2 , 3&4 , 5&6, then loft. But can not create my want.(see result 1)

Step two:

If I loft 1&3&5 ,2&4&6  first. then join. The result like my want,but the two surface no join fully. (see result 2)

Why step one can't create result 2 ?

Views: 57

▶ Reply to This

Replies to This Discussion

Permalink Reply by Chris Tietjen on March 22, 2013 at 5:46am

You have to pick the curves in each group individually and in the correct sequential order that you expect to see in your surface.  You can not use a selection box.  You don't have any control over the selection box ordering process.

Permalink Reply by zhuoming on March 25, 2013 at 8:10pm

Thank you very much, I succeed.

RSS

Translate

© 2013   Created by McNeel Admin.

Badges  |  Report an Issue  |  Terms of Service