Looking for something that is half trim / half boolean ... ish

When trimming closed polysurfaces, is there any way I can keep them closed... Sorta like what boolean difference does, but I don't want the surface used for subtraction to go away.

Views: 55

Replies to This Discussion

Hi Ryan- Difference should work, just set DeleteInput=No

-Pascal

pascal@mcneel.com

Ahh thanks again for your patient help Pascal. As usual it's been right under my nose.

Ryan

RSS

Translate

© 2014   Created by McNeel Admin.

Badges  |  Report an Issue  |  Terms of Service