Hi, 

Is it possible in Rhino to set the standard output units?

I'm using the Mass Properties command a lot for Volume calculation. Is it possible to set the output from mm³ to m³ or other?

Would be great. 

thank you

tom

Views: 104

Replies to This Discussion

Before selecting your object, type _-Volume (with the dash), you will get a command line option to set the units of your choice - that will stay sticky for the session.  If you preselect objects you will not see this setting (highly questionable interface design)

You can also make a button with the following macro :

! _-Volume _Units=Meter


You will still have to run it the first time in a session without preselecting an object, for the same reasons as above.

----H

RSS

Translate

© 2014   Created by McNeel Admin.

Badges  |  Report an Issue  |  Terms of Service