Hi Folks,  I am new to this forum. I've been using Rhino4 for some time, but never really have the grasp on  file storage and location and also  one thing in particular is,  I  want to be able to make a box that  I can fillet all sides and corners.  The box needs to have a different draft on each side  and  about 12" tall.   What i usually get is  something very hard to make the corners by scratch with a lot of building and trimming.

      Well, happy modeling. Mark

Views: 37

Replies to This Discussion

Hi Mark,

you should post this in the "Support" section of this forum, as this isn't an enhancement request. Adding a 3dm file and/or a picture to describe what you want might help to understand your problem.

Have you built a solid and used the command "Fillet Edge"?

Cheers,

Michael

RSS

Translate

© 2014   Created by McNeel Admin.

Badges  |  Report an Issue  |  Terms of Service