surface fillet

hello everyone!

I'm having some issues trying to fillet the 4 sharp corners of the red surface shown in the attached jpegs...

the fillet command is not working because the curves are not planar and I thought to trim manually the 4 corners and then blend the curves in order to get the ''fillet effect''!

but when i try to offset the final surface I have some geometry issues too !

is there any other way to fillet the red surface ?

thanks!

Views: 88

Attachments:

▶ Reply to This

Replies to This Discussion

Permalink Reply by Pascal Golay on March 12, 2013 at 8:58am

Hi Lef- I would make the simple surface - the loft, then BlendCrv the surface edges at the corners- you can adjust the location and shape of the curve in this command, then Trim the surface with the resulting curves.

-Pascal

pascal@mcneel.com

Permalink Reply by Lef Teris on March 12, 2013 at 11:28am

Thanks for the advice Pascal!

your method worked smoothly! :)

RSS

Translate

© 2013   Created by McNeel Admin.

Badges  |  Report an Issue  |  Terms of Service