Hello, I was asked to draw a model of a box to hold an arduino and other components for a friend.  I sent them the STL file to print on their CubePro. The first of seven parts stopped in the middle of the print with a "filament error" ( I did not see the error but this is what I was told.)  He claims to have tried printing it three times and it stopped in the same spot each time so he thinks it is the model.  I ran the model through Slic3r and it printed fine for me.  Has anyone else had problems with the CubePro printer?

I will attach a file with four of the pieces.  The part in red is just a bridge support piece.


Views: 165



© 2021   Created by McNeel Admin.   Powered by

Badges  |  Report an Issue  |  Terms of Service