• Sydney
  • Australia
Share on Facebook
  • Blog Posts (1)
  • Events
  • Groups
  • Photos
  • Photo Albums
  • Videos

Helen's Page

Profile Information

Company, School, or Organization
I am a
Which operating system do you prefer?
Jewelry Design

Helen's Blog

Point editing example in r5 Level 1 training guide - lofted surface

I followed the p.133 Exercise 53 (Control Point.3dm).

When I lofted the surface with which I was to discover that seams were created and therefore control point editing could not be turned on, I found that my lofted surface differed from the one in the guide. My surface edges did not strictly adhere to the curves, ie did not go fully to the pointy control points, therefore did not create seams therefore I could turn on points.

I have looked at tolerances but this does not seem…


Posted on July 17, 2013 at 10:01pm — 2 Comments

Comment Wall

You need to be a member of Rhino Community to add comments!

Join Rhino Community

  • No comments yet!


© 2018   Created by McNeel Admin.   Powered by

Badges  |  Report an Issue  |  Terms of Service