February 2016 Blog Posts (4)

modélisateur 3D joaillerie CAO

Atelier de développement et production en forte croissance basé à Paris recherche un dessinateur/concepteur 3D confirmé.



Description:

Au sein du pôle développement vous devrez assurer la conception de projets de joaillerie et haute joaillerie.

En collaboration avec l'équipe existante vous serez amené à gérer des projets dans leur ensemble.



Objectifs:

- Prise de briefs…

Continue

Added by gary on February 16, 2016 at 2:25am — No Comments

LOOKING TO EMPLOY ENGINEERING DRAUGHTSMAN / DESIGNER

A well established Motorhome manufacturer based in Atlantis, Western Cape, seeks to employ a qualified Engineering Draughtsman / Designer to start duties asap.

Applicants should meet the following minimum requirements:

  • RHINO experience (Engineering design will be advantageous)…

Continue

Added by Motorhome-World on February 15, 2016 at 10:30pm — No Comments

How to Add thickness in a particular Curve using Rhino 4

How to Add thickness in a particular Curve in Rhino 4 



following picture can guide you to add thickness to any curves 

by adding few simple steps while modelling.

  1. Step 1

    Draw curves and type ( in command Bar ) or click on "options" icon

    Medium

  2. Step…

Continue

Added by Deepak Patel on February 6, 2016 at 10:54pm — No Comments

Sweep1 command won't work.

I'm doing the Level 2 tutorials. I'm on exercise 18 - Soft Corners. After I perform the Sweep 1 command to make the first surface. I repeat the Sweep 1 command to make the second surface. But, when I pick the top edge of the surface I just created, it only picks a short section. I've tried using Shift to pick all the edges first and then pick the cross-sections but, that does no good. I would provide a screen shot but, I see no way of doing so. Thanks for any advice or suggestions. I have…

Continue

Added by James Williams on February 1, 2016 at 9:37am — 1 Comment

Translate

© 2017   Created by McNeel Admin.   Powered by

Badges  |  Report an Issue  |  Terms of Service