Atelier de développement et production en forte croissance basé à Paris recherche un dessinateur/concepteur 3D confirmé. |
Added by gary on February 16, 2016 at 2:25am — No Comments
A well established Motorhome manufacturer based in Atlantis, Western Cape, seeks to employ a qualified Engineering Draughtsman / Designer to start duties asap.
Applicants should meet the following minimum requirements:
RHINO experience (Engineering design will be advantageous)…
Added by Motorhome-World on February 15, 2016 at 10:30pm — No Comments
ContinueHow to Add thickness in a particular Curve in Rhino 4
following picture can guide you to add thickness to any curves
by adding few simple steps while modelling.
Added by Deepak Patel on February 6, 2016 at 10:54pm — No Comments
I'm doing the Level 2 tutorials. I'm on exercise 18 - Soft Corners. After I perform the Sweep 1 command to make the first surface. I repeat the Sweep 1 command to make the second surface. But, when I pick the top edge of the surface I just created, it only picks a short section. I've tried using Shift to pick all the edges first and then pick the cross-sections but, that does no good. I would provide a screen shot but, I see no way of doing so. Thanks for any advice or suggestions. I have…
ContinueAdded by James Williams on February 1, 2016 at 9:37am — 1 Comment
2019
2017
2016
2015
2014
2013
2012
2011
© 2021 Created by McNeel Admin.
Powered by