July 2013 Blog Posts (2)

Point editing example in r5 Level 1 training guide - lofted surface

I followed the p.133 Exercise 53 (Control Point.3dm).

When I lofted the surface with which I was to discover that seams were created and therefore control point editing could not be turned on, I found that my lofted surface differed from the one in the guide. My surface edges did not strictly adhere to the curves, ie did not go fully to the pointy control points, therefore did not create seams therefore I could turn on points.

I have looked at tolerances but this does not seem…

Continue

Added by Helen on July 17, 2013 at 10:01pm — 2 Comments

Meet Ronald Rael of Emerging Objects @ Facades+ SFO July 11/12

We're very excited to have Ronald Rael joining us at Facades+ San Francisco. Learn about 3D printing in his Emerging Objects workshop July 12.



http://facadesplus.com/sf2013/



http://www.emergingobjects.com/…

Continue

Added by Gil Akos on July 3, 2013 at 5:14am — No Comments

Translate

© 2017   Created by McNeel Admin.   Powered by

Badges  |  Report an Issue  |  Terms of Service