I followed the p.133 Exercise 53 (Control Point.3dm).
When I lofted the surface with which I was to discover that seams were created and therefore control point editing could not be turned on, I found that my lofted surface differed from the one in the guide. My surface edges did not strictly adhere to the curves, ie did not go fully to the pointy control points, therefore did not create seams therefore I could turn on points.
I have looked at tolerances but this does not seem…
ContinueAdded by Helen on July 17, 2013 at 10:01pm — 2 Comments
We're very excited to have Ronald Rael joining us at Facades+ San Francisco. Learn about 3D printing in his Emerging Objects workshop July 12.
http://facadesplus.com/sf2013/
http://www.emergingobjects.com/…
Added by Gil Akos on July 3, 2013 at 5:14am — No Comments
2019
2017
2016
2015
2014
2013
2012
2011
© 2021 Created by McNeel Admin.
Powered by