James Williams's Blog (1)

Sweep1 command won't work.

I'm doing the Level 2 tutorials. I'm on exercise 18 - Soft Corners. After I perform the Sweep 1 command to make the first surface. I repeat the Sweep 1 command to make the second surface. But, when I pick the top edge of the surface I just created, it only picks a short section. I've tried using Shift to pick all the edges first and then pick the cross-sections but, that does no good. I would provide a screen shot but, I see no way of doing so. Thanks for any advice or suggestions. I have…

Continue

Added by James Williams on February 1, 2016 at 9:37am — 1 Comment

Latest Blog Posts

Most Popular Blog Posts

Monthly Archives

2016

Translate

© 2019   Created by McNeel Admin.   Powered by

Badges  |  Report an Issue  |  Terms of Service