I'm sure there's a simple answer to this question.  Bear in mind that I've never in all my years of using Rhino come across this situation before.  The model is to be located as seen in three of the four view with the cutwater at 0,0,0.  However, as seen, in perspective the model appears in negative territory, nowhere near where it should be.  One thing for sure, as I get older the less I know...cheers, Rob

Views: 124


You need to be a member of Rhino Community to add comments!

Join Rhino Community


© 2020   Created by McNeel Admin.   Powered by

Badges  |  Report an Issue  |  Terms of Service