"I now see, that command _Pull works.
What is the explanation for this difference?"
Niels Foldager's Page
Latest Activity
Niels Foldager replied to Niels Foldager's discussion Problems with _Project in the group food4Rhino
Niels Foldager added a discussion to the group food4Rhino
Problems with _Project
Please, see the file attached.The curve is a closed polycurve with 4 curve segments.When I try to _Project the polycurve to the planar surface, only the lower curve is projected.Please, see the result in the file attached.It doesn't matter where on the polycurve I click to select it.I stay in Front view during the whole procedure.What do I miss?Best regards,NielsSee More
Niels Foldager replied to Niels Foldager's discussion Off-set opens polycurve ? in the group food4Rhino
"Nobody has the answer?"
Niels Foldager added a discussion to the group food4Rhino
Off-set opens polycurve ?
On the attached file:The inner curve is an offset of the outer curve.The outer curve is a closed polycurve. However, the offset (inner) curve is an open polycurve.How can that be?How to avoid (or repair) that the offset curve is open?I need the two curves for 2rail, but that requires that both curves are closed (or open).See More
Niels Foldager replied to Niels Foldager's discussion Rhino-model from STL-file? in the group food4Rhino
"@moegamat
Thank you for your reply.
> then boolean union the meshes
Ok. But then my support becomes part of the model. I need top keep them as separate objects because the supports shall be printed using soluble material. Is there a…"
moegamat replied to Niels Foldager's discussion Rhino-model from STL-file? in the group food4Rhino
"You can design the support using nurbs surfaces, make sure the supports are closed surfaces.
Convert nurbs to meshes than boolean union the meshes (use mesh tools toolbar).
In the biblical sense you can convert a mesh to nurbs but that is beyond…"
Niels Foldager added a discussion to the group food4Rhino
Rhino-model from STL-file?
Is it possible to convert a stl-model to a Rhino-model (NURBS)?The actual problem, that makes me ask right now, is that I received an stl-file for 3D-printning. I want, to insert some supports (that the slice-program can't). I think that I need to convert it to NURBS, so that I can snap to it and so on, and make full use of Rhino's tools.I very mush appreciate any hints.Best regards,Niels See More
Profile Information
- Company, School, or Organization
- Copenhagen Suborbitals
- I am a
- Teacher, Hobbyist
- Which operating system do you prefer?
- Windows
- Discipline/Occupation
- Aircraft/Aerospace, Medical
Comment Wall
- No comments yet!
© 2020 Created by McNeel Admin.
Powered by
