May 2014 Blog Posts (1)

strange control points of a extruded surface

after I extrude a curve to a surface, i get some wired looking control point results.

it´s a curve 2 degree (3pt arc) and I extrude it by clicken the ctrl key + gumball.

even when I use the regular extrude commande the result of the control pt´s should be a differnt one.

after rebuilding the surface with more pt´s I still get the same result.

what is…


Added by patric günther on May 29, 2014 at 2:41pm — No Comments


© 2021   Created by McNeel Admin.   Powered by

Badges  |  Report an Issue  |  Terms of Service