May 2015 Blog Posts (2)

found the problem

Regarding my last post with the perspective view issue, what I perceived to be a problem was easily set right by right clicking on the view tab, and setting the origin where I wanted it to be.  All is well in the land of pharticus anteequs.  Regards, Rob

Added by Rob Ladd on May 1, 2015 at 10:06am — No Comments

unusual perspective view

I'm sure there's a simple answer to this question.  Bear in mind that I've never in all my years of using Rhino come across this situation before.  The model is to be located as seen in three of the four view with the cutwater at 0,0,0.  However, as seen, in perspective the model appears in negative territory, nowhere near where it should be.  One thing for sure, as I get older the less I know...cheers, Rob…


Added by Rob Ladd on May 1, 2015 at 9:57am — No Comments


© 2020   Created by McNeel Admin.   Powered by

Badges  |  Report an Issue  |  Terms of Service