November 2013 Blog Posts (3)

Lower the amount of edit/control points and line segments in text curves.

How do I lower the amount of edit/control points in a drawing with lots of curved text lines ?

In the original, made as "ai" file, there appear less edit points when only opened in Rhino 5.0

The laser cutter used for metal sheet, reads an awful lot of small curves after saving the original drawing as a DXF laser file.

I would like to know what causes the increase of line segments and how to simply control this.

Thanks,

Benjamin

Added by Benjamin on November 27, 2013 at 12:00am — No Comments

Rotating .IES file

Hey guys.

I'm trying to rotate an asymmetric IES file within rhino! But it seems to treat it as a cone light, and can not rotate it. I can pan and tilt no problem but not rotate.

Any one got any recommendations..

Appreciate any help - thanks

All the best
Nikolaj

Added by Nikolaj Birkelund Pedersen on November 25, 2013 at 1:52pm — 4 Comments

New Prototyping Shield by Andy Payne featured this Weekend at Mode Lab

Andy Payne will be featuring the new version of his Prototyping Shield this weekend at the Making Interactive Prototoypes workshop.

 

"Mount your shield on top of your Arduino Uno and start bringing your ideas to life!"

 

http://lab.modecollective.nu/lab/making-interactive-prototypes-w-andy-payne/…

Continue

Added by Gil Akos on November 1, 2013 at 8:26am — No Comments

Translate

© 2017   Created by McNeel Admin.   Powered by

Badges  |  Report an Issue  |  Terms of Service